Counter-depth french door refrigerator with wave-touch® controls (39 pages)
Summary of Contents for Electrolux ÖKO-SANTO 1554-6 iU
Page 1
ÖKO-SANTO 1554-6 iU Built-In Refrigerator Operating and Installation Instructions...
Page 2
Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance.
Intended use • The refrigerator is intended for use in the home. It is suitable for the storing of food at low temperature. If the appliance is used for pur- poses other than those intended or used incorrectly, no liability can be accepted by the manufacturer for any damage that may be caused.
Page 5
• Do not operate any electrical appliances in the refrigerator/freezer (e.g. electric ice cream makers, mixers etc.). • Before cleaning the appliance, always switch off the appliance and unplug it, or pull the house fuse or switch off the circuit breaker.
Disposal Appliance Packaging Information All materials are environmentally friendly. They can be dumped or burned at an incinerating plant without danger. About the materials: The plastics can be recycled and are identified as follows: >PE< for polyethylene, e.g. the outer covering and the bags in the interior.
Climate classification If the refrigeration appliance is installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to prevent the formation of condensation on the outside of the appliance.
Reversing the door The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires. Warning! When changing the side at which the door opens, remove plug from the mains. Left door opening: Remove the grid from the appliance by pulling it towards.
Page 9
To reverse the opening direction of the door, proceed as shown in the figures:...
Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. Remove covering and adjust the bracket locking nuts. Push the appliance into place. The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is...
Fitting the plinth Important! For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm.
The mains cable may only be changed by a qualified electrician or competent person. If your appliance needs repairing, please contact your local AEG Service Force Centre. Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
Description of the appliance View of the appliance Butter/cheese compartment Sliding shelf Bottle shelf Vegetable drawers Storage shelves Thermostat Prior to Initial Start–Up Please clean the appliance interior and all accessories prior to initial start-up (see section: “Cleaning and Care”).
Starting up and temperature regulation Connect the appliance to the mains electricity supply. When the refrigerator compartment door is opened, the internal light- ing is switched on. The temperature selector knob is located on the right hand side of the refrigerator compartment.
Interior Accessories Storage shelves/wire trays Various glass or plastic storage shelves and wire trays are included with your appliance - different models have different combinations. You should always slide one of the full size glass storage shelves into the lowest set of guides, above the fruit and vegetable drawers, and keep it in this position.
Defrosting The fridge defrosts automatically The rear wall of the fridge covers with frost when the compressor is running, and defrosts when the compressor is off. The water from the thawing frost evaporates by itself. Switching off the appliance To switch off the appliance, turn the temperature regulator to positi on "0".
Do not allow such substances to come into contact with appliance parts. • Do not use any abrasive cleansers. Remove the food from the refrigerator. Store it in a cool place, well covered. Switch the appliance off and remove the plug from the mains, or dis-...
• Do not leave the door open any longer than necessary. • Do not set temperature any colder than necessary. • Put frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge. What to do if ...
Page 21
Symptom The food is too warm. Interior lighting does not work. Heavy build up of frost, possibly also on the door seal. The compressor does not start immediately after changing the temperature setting. Water in the bottom of the cabinet. Possible Cause Temperature is not properly adjusted.
Change the defective light bulb. Refit the light bulb cover and the screw. Put the refrigerator back into operati- Service & Spare Parts In the event of your appliance requiring service, or if you wish to pur- chase spare parts, contact your local AEG Service Force Centre by...
Customer Care For general enquiries concerning your AEG appliance and for further information on AEG products, contact our Customer Care Department by letter or telephone, as follows: Customer Care Department AEG Domestic Appliances 55-77 High Street Slough Berkshire SL1 1DZ Tel: 08705 350350 Noises during Operation The following noises are characteristic of refrigeration appliances:...