McIntosh MDA1000 Owner's Manual page 17

selected and the LEVEL Control is rotated or the LEVEL Up(+)
/ Down (-) Push-buttons on the remote control are pressed, the
Front Panel Alphanumeric Display will momentarily indicate
"BYPASS ON". Refer to figure 10.
Setup
Pressing the SETUP Push-button activates the Setup Mode
of the MDA1000 and allows customizing various operating
functions. Refer to the SETUP Section of this Owner's
Manual starting on page 12.
Reset of Microprocessors
In the event that the controls of the MDA1000 stop func-
tioning, push the POWER switch OFF and wait about two
minutes. Then push the POWER switch ON followed by
pushing the STANDBY/
ON Push-button. This will
reset the MDA1000 mi-
croprocessors and the Au-
dio Control Center will be
returned to normal opera-
tion.
Note: The above
condition is usually
caused by either
interruptions in AC
power and/or
major changes that
may occur in AC
power line voltage.
Figure 15
How to Operate the MDA1000
17