NETGEAR WNA3100 - Wireless-N 300 USB Adapter User Manual page 25

Figure 2-4
2. Enter the network settings.
a. In the Profile field, type a name for the profile.
b. In the Network Name (SSID) field, select a network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
matches exactly the SSID used by the wireless network.
c. In the Network Type section, make sure that Access Point (Infrastructure) is selected.
This setting lets you connect to a wireless network. For help with Ad Hoc mode, see
"Setting Up a Computer-to-Computer (Ad Hoc) Profile" on page
3. Click Save Profile.
All the configuration settings are saved in this profile.
4. To use the profile, click Apply.
5. Make sure you can connet to the network.
Use a browser to connect to the Internet, or check for file and printer access on your network.
You can check the status bar in the Smart Wizard for the current connection status. If you
cannot connect, see
Wireless-N 300 USB Adapter WNA3100 User Manual
"Troubleshooting Your Wireless Connection" on page
v1.0, December 2009
2-6.
4-2.
2-5