Using Push 'N' Connect To Join A Network; Creating A Profile To Connect To A Wireless Network - NETGEAR WNA1100 - Wireless-N 150 USB Adapter User Manual

Wireless-N 150 USB Adapter WNA1100v1 User Manual

Using Push 'N' Connect to Join a Network

If there is a WPS network in your area, you can use Push 'N' Connect to join it and automatically
configure the wireless security settings for your adapter.
Note: To use Push 'N' Connect you need to know the location of the wireless router, and
you must have access to the router so that you can push its WPS button.
To join a network:
1. On the Networks tab, select the network and click Connect.
If the router supports Push 'N' Connect (also called WPS), the following screen displays:
Figure 2-3
2. Press and hold the push button on the side of the wireless-N USB adapter for 2 seconds. The
LED flashes.
3. Follow the wizard steps to push the router's WPS button within 2 minutes, and connect to the
wireless network.

Creating a Profile to Connect to a Wireless Network

You can create and save a profile from the Settings tab.
To set up a profile:
1. Click the icon to open the Smart Wizard. The Settings tab displays:
2-4
v1.0, December 2009