Joining Wireless Networks - NETGEAR WN3000RP-100PAS Workshop Manual

The best performance is delivered when both the Link Rate LED
-
Extender Connection LED
A workable performance is delivered when the Link Rate LED is amber
-
PC to Extender Connection LED
If you cannot get a wireless connection working, you can use an Ethernet cable to
connect your computer to the Extender. See
Ethernet Cable

Joining Wireless Networks

To join a wireless network you must know its network name (also called the SSID) so that you
can select it. If the network is secure, you must know the passphrase or wireless key. If the
Extender does not connect to the network that you chose, the following message displays:
Connection was not established to the selected network.
If this happens it could be due to one of these reasons:
The network name, passphrase, or key might have been typed incorrectly. Click Cancel,
•
use the Smart Wizard to select the network from the list, and retype the passphrase or
key. This is case-sensitive. PASSWORD25 is not the same as Password25 or
password25. See
If the Smart Wizard does not find your wireless network (it is not displayed in the Select
•
Existing Network screen), check to see if your wireless network is still up and running.
Make sure that the router is turned on. If possible, move the Extender closer to the router
and click Try Again.
If the Extender WLAN LED is red, this indicates a poor wireless connection. The best
•
connection is established when there is a clear line of sight between the Extender and the
router you are connecting to. Make sure that there are no physical obstacles between the
Extender and the router, and try to move the Extender closer to the router.
If you use the Smart Wizard, and the Extender cannot connect to the router or cannot get an
IP address from the router, it displays the following message:
You are not able to connect to the Internet. Click Continue to run through set up again to
connect to your network.
If you click Continue, the Smart Wizard starts again (see
on page 9). If you click Exit, the Status screen displays with menu selections on the
Extender
left (see
Log In to the Extender
Universal WiFi Range Extender WN3000RP
are green.
on page 8.
Use the Smart Wizard to Set Up the Extender
on page 8).
Troubleshooting
is green.
Connect a PC to the Extender with an
Use the Smart Wizard to Set Up the
5
and the PC to
and the
on page 9.