Advertisement
Typical Setup Configuration for the WAP
For specific setup and configuration instructions for your
wireless camera, refer to the camera's installation guide.
1. If using wireless connectivity, attach the two antennas to the WAP. Orient
each antenna vertically and tighten the knurled connectors.
2. Connect the Power Transformer wire to the 12V / 1A connector on the
WAP back. Plug the Power Transformer into an outlet.
NOTE: The Power Transformer must be powered by a non-switchable
power outlet.
IMPORTANT:
• When setting up a wireless configuration in very large buildings or
buildings with dense walls, wireless communications may be marginal. It is
best to first configure the system in the same room. Then upon successful
configuration, place each wireless camera in the desired location.
• If using more than one wireless camera, each must be configured for
wireless security.
• If using a router instead of Honeywell's WAP, please ensure your router is
configured for DHCP. (This is the default setting for most routers.) If you
are unsure, you can access the router's configuration page and set it for
DHCP if necessary (refer to the router's manual). Since the operation of
each router varies, please refer to the router's manufacturer for support.
• Test the system to ensure all cameras exhibit good communications.
Ê800-05000:Š
800-05000 11/09 Rev. A
Typical configuration using a mix of wired and wireless cameras:
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Copyright © 2009 Honeywell International Inc.
www.honeywell.com/security
WARRANTY
For the latest warranty information go to:
http://www.security.honeywell.com/hsc/resources/wa/
Advertisement
