Table of Contents
Advertisement
Quick Setup List -
Page
Setup Procedure
4
Uncrating
4
Battery Activation &
Installation
5
Rider Assembly
6
Check Fluid Levels
7
Mower Assembly
7
Lubrication
8
SAFETY CHECKS
8
Burnish Electric Clutch
7/2005
Steps to Perform
❏ Remove crate & banding.
❏ Place transmissions in PUSH position & roll off skid.
❏ Charge the battery (Note: proceed with other setup steps
while battery is charging).
❏ Test battery with hydrometer or load-tester.
❏ Install & secure battery.
❏ Install the seat and connect the seat switch
❏ Install ground speed control levers.
❏ Fill & check Engine oil level.
❏ Check transmission fluid level.
❏ Reduce & check tire pressures
(Front tires 40 psi, rear tires 15 psi).
❏ Torque mower blade bolts.
❏ Lubricate all grease & oil points.
❏ Check for LOOSE HARDWARE.
❏ Check all OPERATOR CONTROLS.
❏ Test PARKING BRAKE.
❏ Perform MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
❏ Perform SAFETY INTERLOCK SYSTEM CHECK.
❏ Burnish electric clutch (run for 15 seconds, repeat 10 times) .
❏ Repeat MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
3
FastCut Hydro Drive ZTR
TP 300-7237-IR-HZ-N
Hide quick links:
Advertisement
Table of Contents
