Floppy Disk Drive Problems; Hard Drive Problems - Fujitsu LifeBook C series User Manual

Problem
The media player will
not play international
DVD titles
The LifeBook notebook
fails to Auto-Play a DVD
movie.

Floppy Disk Drive Problems

You cannot access your
floppy disk.

Hard Drive Problems

You cannot access your
hard drive.
You cannot access your
hard drive. (continued)
Keyboard or Mouse Problems
Possible Cause
The region code for the DVD
does not match that of the media
player.
The media player software has
not been installed.
You tried to write to a write
protected floppy disk.
Floppy disk is not loaded
correctly.
BIOS setup utility states Floppy
Disk Controller:
Disabled.
Security is set to protect access to
floppy disk data.
The setup utility is incorrectly set
for your internal (Primary
Master) or optional second hard
drive (Primary Slave).
The wrong drive designator was
used by an application when a
bootable CD-ROM was used to
start the LifeBook notebook.
Security is set so your operating
system cannot be started without
a password.
T r o u b l e s h o o t i n g
Possible Solutions
All Fujitsu notebook DVD players are set to play
DVD titles with region code number 1, which is
specified for the North American market. The
region number is a regional restriction code defined
by the DVD Forum acting on the requirements of
Hollywood. Different region codes are recorded on
video DVD titles for publication in different areas of
the world. If the regional code of the DVD player
does not match the regional codes on the titles, then
playback is impossible.
NOTE: You can change the region code on the DVD
player using the Properties menu of the DVD soft-
ware. Note, however, that you can only change the
region code up to four times. After the fourth
change, the last region code entered becomes
permanent, and cannot be changed.
Locate and install the DVD-ROM Applications CD.
Eject the floppy disk and set it to write enable. (See
Internal Floppy Disk Drive on page 37 for more infor-
mation)
Eject floppy disk, check orientation and re-insert.
(See Internal Floppy Disk Drive on page 37 for more
information)
Revise the setup utility Main menu settings to
enable Diskette Controller. (See BIOS Setup Utility
on page 27 for more information)
Verify your password and security settings.
Revise BIOS settings to set both Primary Master
and Primary Slave correctly. (See BIOS Setup Utility
on page 27 for more information)
Verify drive designator used by application is in
use by the operating system. When the operating
system is booted from a CD, drive designations
are automatically adjusted.
Verify your password and security settings.
73