Table of Contents
Advertisement
(SECTION TWO: Unpacking and Placement continued)
To Attach the Loudspeaker Grill
Each LAT is equipped with a snap-on grill, which consists of the grill cord strung
between two metal bars. To install the grill, follow these steps.
1.
Lift the loudspeaker grill from the grill box, using the grill bars on each end.
2.
Locate the end of the grill. On the LAT–1 and LAT– 2 loudspeakers, one end of the
grill will be placed at the base of the loudspeaker; the other end will be placed
at the cap. On the LAT–C loudspeaker, one end of the grill will be placed on the
left cap and the other end will be placed on the right cap.
3.
Gently guide the grill locator pins into the two holes on the loudspeaker base.
4.
Grasp the remaining grill bar, allowing it to rest between the thumb and forefinger
of each hand.
5.
Pull firmly to stretch the grill cords, until the grill locator pins align with the two
holes on the loudspeaker cap.
6.
Gently guide the pins into the holes. You hear a click when the grill is in place.
Note
Be careful not to scratch the surface of the loudspeaker with the grill locator pins.
To Detach the Loudspeaker Grill
The loudspeaker grill remains in place while you play music. However, if you wish to
move the loudspeaker, first detach the loudspeaker grill.
1.
Grasp the grill bar that is attached to the loudspeaker cap.
2.
Gently pull the bar straight out, so that the grill locator pins slide out of the
holes on the loudspeaker cap.
3.
Remove the grill bar from the base of the loudspeaker.
To protect the grill, Krell recommends placing it back in the grill box until you are
ready to reinstall it.
Note
The grill should be cleaned periodically to remove accumulated dust. Gently wipe the grill from
top to bottom using a soft, dry, lint-free cloth. Do not use rubber conditioner or solvent.
12
Advertisement
Table of Contents
