Table of Contents
Advertisement
(SECTION TWO: Unpacking and Placement continued)
To Attach the Loudspeaker Grille
Attach the grille to the loudspeaker before you play music. Each Lossless Acoustic
Transducer (LAT) is equipped with a snap-on grille, which consists of the grille
cord strung between two metal blocks. The grille is shipped in the accessory box
marked "grille". To install the grille, follow these steps.
1.
Grasp the grille blocks on each end of the grille, and lift the loudspeaker grille
out of the grille box.
2.
On the LAT–1000 and LAT– 2000 loudspeakers, position one grille block on the
bottom front of the loudspeaker.
On the LAT–C1000 loudspeaker, position one grille block on the left front of the
loudspeaker.
3.
Gently guide the grille locator pins into the two grille holes on the bottom front
of the loudspeaker.
On the LAT–C1000 loudspeaker, position one grille block on the left front of the
loudspeaker.
4.
Grasp the remaining grille block, allowing it to rest between the thumb and fore-
finger of each hand.
5.
Pull firmly to stretch the grille cords, until the grille locator pins align with the
two holes on the top front of the loudspeaker.
On the LAT–C1000 loudspeaker, stretch the grille cords to the right.
6.
Gently guide the pins into the grille holes. You hear a click when the grille is in
place.
11
continued
Advertisement
Table of Contents
