Electrolux 316520101 Use And Care Manual page 10

Getting Started
10
Setting clock at power up
You will be prompted to enter the time of day in the
event of a power failure or when you first provide
electric power to your appliance.
• When your appliance is first powered up, 12:00
will flash in the display.
• Enter the time of day using the numeric key
pads and press START to set.
If an invalid time of day is entered, the control will
triple beep. Re-enter a valid time of day and press
START. If CANCEL is pressed your clock will start
with the time set for 12:00.
Select the user pref key to modify the time of day
during other situations such as day light savings.
Wave-Touch™ display modes
Sleep mode
Your control will remain in a sleep mode -Fig.1-
when not in use, unless there is a hot element.
Only the clock will display during this mode. You
will need to wake the control to begin any function.
Awake mode
To awake the control -Fig. 2- touch within the
display panel. If the control panel is not touched
again within 2 minutes, the control will return to the
sleep mode. To start cooking you must select
either the upper oven, lower oven, or a surface
element. User preferences will be available during
this mode as well as timers, oven light and the
control lock.
Sleep mode
Awake mode
Timers
The two timers provided with the oven control
serve as extra reminders in the kitchen. When a
timer reaches less than 1 minute the display will
start to count down in seconds. When the time
runs out the active timer will beep, "00:00" will
display and the timer key will flash.
The following time settings apply to the timers:
• Min. time: 1 minute
• Max. time: 11 hours 59 minutes
See example below to set the timer for 5 minutes:
Example
Step
1. Press TIMER
2. Enter 5 minutes
3. Press TIMER
To cancel after setting the timer, press the TIMER
key again.
NOTE
The timer(s) will not affect the cooking process.
Press
Fig.1
Fig.2