Table of Contents
Advertisement
Cleaning the Main Unit
To remove dirt from the cabinet, lightly wipe the surface with a soft cloth.
For adhered dirt, wipe with a cloth soaked with neutral detergent diluted with water and wrung tight. Then wipe the
surface with a dry cloth.
Replacing the Fluorescent Lamps
The fluorescent lamps used with this unit are commercially available. When a lamp has burned out, purchase one by
specifying the type name (FPL13EX-N).
Turn the power off at the
1
POWER switch, and discon-
nect the power plug from the
AC outlet.
Soon after the lamp was lit, wait for 15 minutes or
more for the lamp to cool down.
Rotate the lamp holder up-
2
wards, and remove the fluo-
rescent lamp.
As the fluorescent lamp may be hot, we suggest
wearing gloves.
Glove
Insert the new fluorescent
3
lamp into the socket.
[ Before replacing a lamp, wait at least 15 minutes for it to sufficiently cool down to avoid
burning your fingers.
Caution for
[ NEVER apply excessive force to a tube. It may break, causing injury.
replacement
[ Replacement of the fluorescent lamp under the document stage must be referred to your
dealer. Never attempt to replace it yourself.
38
Do NOT replace
it yourself
**BARCO 038-043(E)
38-39
MAINTENANCE
While pressing the lamp to-
4
wards the socket, fit it in the
holder.
A clicking sound is heard.
If no clicking sound is heard,
press the holder with your fingers.
Note
[ Be careful that the lamp will not be dam-
aged by the holder.
[ Make sure that the lamp is firmly secured
in the socket and holder.
Replace the lamp on the other
5
side in the same manner.
Caution
MAINTENANCE
Cleaning the Mouse Ball
If dirt or foreign subject is stuck to the mouse ball, the ball may not roll smoothly, causing difficulty in moving the
electronic pointer. In such a case, clean the ball as described below.
Unlock the frame at the bot-
1
tom of the mouse and re-
move the ball.
Using a pointed tool, turn the two guide holes of
the frame in the direction of the arrow (to the
left) to release the lock.
Be careful not to drop the ball.
Wipe off the contamination
2
from the ball's surface.
Wipe away stains with a clean dry cloth.
For stubborn stains, soak a soft cloth with a
neutral detergent and thoroughly wipe the ball
surface of the ball.
2000.7.18, 8:19 PM
Clean the ball support and
3
roller block.
Using a cotton swab, lightly wipe the block and
while rotating the rollers.
Mount the ball and lock the
4
frame.
Insert the ball into the mouse. Attach the frame
and turn it to the right using a pointed tool to lock.
39
Advertisement
Table of Contents
