Table of Contents
Advertisement
VOH703
Red: +12 VDC
(Accessory Cir.)
Black: Ground
Am/Fm
Antenna
TO
FACTORY
RADIO
Dash Radio
TO
12 VDC Power and Ground
OPTIONAL
ADDITIONAL
MOINTOR
1) Make the connections to the vehicle for the 12 pin wiring harness.
2) Remove screws on PCB Cover. Open the cover to gain access to Mini-Din Connector on main
PCB. (Cover will remain attached to rivet hole).
3) Insert the Circular Mini-Din Connector of the source Component Harness through the wire tie loop
on the main PCB and into the Mini-Din Connector on the main PCB.
4) Pull the wire tie loop tight and cut off the excess.
5) Connect the Power Harness to the mating connector on the Video Monitor.
6) Connect the wired RF Modulator and / or the remote headphone jacks to the video monitor if those
options are being included.
7) Connect power harness to vehicle's electrical system by tapping into an accessory hot line.
8) Reinstall PCB cover using the 2 screws.
9) Mount and connect the Television antenna.
10) Verify all functions of the System before final mounting of the finished assembly.
Note: A second VCP or other A/V Component can be connected to the video monitor system using a
second Source Component Harness (purchased separately, part number: 8010730). This second
harness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above.
A/V Source Definitions:
1= TV Tuner
2= VCP (right Mini-Din on main PCB)
nd
3= 2
VCP (or game or future DVD, etc..... left Mini-Din)
Power Harness
Item # 4
choke
Optional Hard Wired FM Modulator Output
12 VDC Power and Ground
Left
Input
FM
Modulator
1070610
Right
*Refer to Instructions with the RF
Input
Modulator Kit for further details.
To Secondary AV Monitor
INPUT
VIDEO
Auxillary
video display
Optional External Speakers
Green
(Right+)
Black
(Ground)
Gray
(Left+)
Note: cables
exiting the pod
should be routed
as shown.
12 Pin Power signal
Harness Item #3
RCA-Female
LEFT
WHITE
Patch Cord
RCA Male to Male
RIGHT
RED
RCA-Female
RCA-Female
LINE
OUT
Patch Cord
VIDEO
RCA Male to Male
IR LED:
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Window on the Face of the VCP.
-6-
Mini-Din Connectors
2
1
Accessory
Accessory
Harness
Harness
Item# 2
Item# 2
Red RCA (Audio Right)
White RCA (Audio Left)
"Y" Adapter
Power Connector
4 Pin
for use with
Non-Stereo
Installations
Item# 5
TV antenna
(If applicable)
Yellow RCA (Video)
Advertisement
Table of Contents
