Installation - Baumatic BW1000W Instruction Manual

2- INSTALLATION

2.1 - Removing transit bolts
A
B
C
D
2.2 -Plumbing connection
The user will require a tap with a 3/4" gas screwthread outlet and a drain
situated between 50 and 80 cms. above floor level. The watermain pressure
must be between 0,4 and 10 bar inclusively.
Proceed as follows:
-Let the water run for a while before connecting the hose.
-Connect the water inlet hose applying the rubber joint provided in the fittings
equipment bag.
-Position the drainage hose inside a hose of a larger diameter, or rest it well
fastened against any kind of drain at the height indicated.
-Neither of the hoses should be twisted or kinked.
- Use new tubes for connecting to the water supply.
After removing the external packing
the drum must be released before the
machine is used.
This is done in the following manner:
1 . ) U n s c r ew a n d r e m ove t h e f o u r
screws A-B-C-D.
2.) Push with a screwdriver at an angle
in the screw holes until the four spacers
(H) fall.
These must be recovered and kept.
3.) It is very important to recover these
four spacers (H) because they could
cause damage if they remain inside the
H
machine and also because they will be
required to move the machine in the
case of moving house.
H
H
C
THERMO
C
C- Cold water connection.
H- Hot water connection.
The "H" connection can only
be applied in those machines
f itted for this (Bithermical).
5