Related Manuals for AT&T XG1000
Summary of Contents for AT&T XG1000
- Page 1 STARTER KIT INSTALLATION MANUAL © 2007 AT&T Knowledge Ventures. All rights reserved.
-
Page 2: First Time Setup
INTRODUCTION TO YOUR FIRST TIME SETUP /// AT&T REMOTE MONITOR STARTER KIT /// Thank you for your purchase of the AT&T Remote Monitor Starter Kit. The XG1000 Controller PREPARATION: (the terms “Controller” and “Gateway” should be viewed as synonomous), a small dedicated YOUR STARTER KIT CONTAINS THE FOLLOWING ITEMS: computer, allows you to access and control cameras and other devices in your home, and make XG1000 Controller... - Page 3 HARDWARE INSTALLATION: 4. Bring your IP Camera [C1], AC Power Supply [A2], HomePlug Turbo PLC Ethernet Adapter [H2], and Ethernet Cable [E3] to the location in your home that you wish to install your IP Camera [C1]. FOLLOW THE STEPS BELOW SET UP YOUR AT&T REMOTE MONITOR STARTER KIT: 1.
-
Page 4: Device Discovery
CONTROLLER REGISTRATION: 4. When the controller registration has completed, you will see a confirmation message as 1. When you purchased your AT&T Remote Monitor system, you created a remote account in the following picture. After you successfully register your controller you may be prompted to with a UserID and Password. -
Page 5: Time Zones
USING THE SYSTEM WITH A CORPORATE FIREWALL /// LIVE VIDEO /// If you are using the AT&T Remote Monitor system in an environment that is protected For each discovered camera you will see a Snapshot of the view associated with the camera when by a corporate firewall, you may need to make some settings that will allow you to get the best you click on the ‘LIVE VIDEO’... - Page 6 OPTIMIZING YOUR VIDEO PERFORMANCE: XG1000 CONTROLLER /// To ensure that your video performance is optimized INDICATORS: you can port forward your router. To do so, please There are ten indicators on the front of the controller. repeat the controller registration process (refer to the instructions, steps 1-4, found on pages 5 and 6 of this manual) where you will be prompted with instructions on port forwarding.
- Page 7 BOOT SEQUENCE MOBILE OPTION: When the controller is first powered up, the bottom five LED’s on the front panel go If you have a JAVA enabled wireless phone from AT&T you can access the system from through a boot-up sequence. The lights start out as Red, go to Amber and then Green.