Rear View; Bottom View - HP Neoware m100 - Mobile Thin Client Quick Start Manual

Unpack
Your HP Neoware thin client is typically shipped with the following items:
❏
❏
❏
Carefully remove the contents of the container and keep the carton and the
packing materials in case you need to send the thin client in for service.
Setup/Power Up
1. Connect the AC adapter cable to the power port.
2. Plug the power cable into the adapter and connect the other end into a wall
outlet.
CAUTION: When using the AC adapter, make sure the power
Ä
source falls within the system's compatible range of 100-240 volts
AC. Never use the AC adapter if the voltage falls outside of this
range (watch for this when travelling to other countries).
3. If applicable, connect the LAN cable to the LAN port.
HP Neoware m100 thin client
AC adapter and power cable
This Quick-Start Guide

Rear View

1 Kensington lock slot
2 USB ports (3)
3 LAN port 10/100 base-T
4 Modem port
5 Vents
6 VGA port
7 AC power port

Bottom View

1 Tilt feet
2 Battery bay
3 Battery release latch
4 Memory bay
3