AEG SANTO 2842-6 i Operating And Installation Instructions page 24

Open the appliance door and the
furniture door at 90¡. Insert the
8mm
small square (B) into guide (A).
Put together the appliance door
and the furniture door and mark
the holes as indicated in the figu-
re. Remove the squares and drill
holes with ¿ 2 mm at 8 mm from
the outer edge of the door. Place
A
the small square on the guide
again and fix it with the screws
supplied.
B
PR167
Should the lining up of the furnitu-
re door be necessary, use the
clearance of slots.
At the end of operations, it is
necessary to check if the door of
the furniture closes properly.
PR168
Fix cover (D) on guide (B) until it
clips into place.
B
D
PR167/1
24