Table of Contents
Advertisement
OTHER INFO
DISCLAIMER AND LIMITATION OF LIABILITY
VTech
Electronics North America, L.L.C. and its suppliers assume no responsibility for any damage or loss
®
resulting from the use of this handbook. VTech
Electronics North America, L.L.C. and its suppliers assume
®
no responsibility for any loss or claims by third parties that may arise through the use of this software. VTech
®
Electronics North America, L.L.C. and its suppliers assume no responsibility for any damage or loss caused by
deletion of data as a result of malfunction, dead battery, or repairs. Be sure to make backup copies of important
data on other media to protect against data loss.
COMPANY : VTech
Electronics North America, L.L.C.
®
ADDRESS : 1155 West Dundee Rd, Suite 130, Arlington Heights, IL 60004 USA
TEL NO : 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ices-003.
Cet appareil numérique de la classe b est conforme à la norme nmb-003 du Canada.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
9
Advertisement
Table of Contents
