Table of Contents
Advertisement
Heavy build up of frost, pos-
sibly also on the door seal.
Unusual noises.
The compressor does not
start immediately after chan-
ging the temperature set-
ting.
Water on the floor or on sto-
rage shelves.
If, after carrying out the necessary checks there is still a fault with
your appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested
checks have been made as the engineer will make a charge if the
fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee
service calls.
Changing the light bulb
Warning! There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it, or pull the fuse or the cir-
cuit breaker. Light bulb data: 220-240 V, max. 15 W
14
Door seal is not air tight
(possibly after changing
over the hinges).
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a pipe,
on the rear of the appliance
is touching another part of
the appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Carefully warm the leaking
sections of the door seal
with a hair dryer (not hotter
than approx. 50 ¡C). At the
same time shape the war-
med door seal by hand such
that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.
Advertisement
Table of Contents
