Installing The Memory Module - HP ProLiant SL165s Installation Instructions Manual
Hp proliant sl165s g7 server installation instructions
Hide thumbs
Also See for ProLiant SL165s:
- Implementation manual (26 pages) ,
- Overview (20 pages) ,
- Error prevention manual (12 pages)
Table of Contents
Advertisement
NOTE: For specific supported hard drive configurations and
cable routing, refer to HP ProLiant SL165s G7 Server
Maintenance and Service Guide located on the HP website:
http://www.hp.com/support/ProLiant_SL165sG7_MSG_en
CAUTION: Drives can be damaged by static electricity. Before
handling drives, touch an unpainted metal surface to discharge
static electricity.
To install the LFF hard disk drive in the server tray:
1.
Unlock the HDD carrier latches.
2.
Lift the HDD carrier handle up.
3.
Insert the HDD carrier and align the pins.
4.
Press the HDD carrier handle down.
5.
Lock the HDD carrier latches.
Figure 6 Installing the hard disk drive
Installing the Memory Module
Memory Module Population Order (From left to right)
RDIMM population order without QR DIMM
Memory
1
7
4
10
Socket
UDIMM population order without QR DIMM
Memory
1
7
4
10
Socket
Population order with QR along with SR/DR DIMM
Memory
2
8
5
11
Socket
3
9
6
12
2
8
3
9
6
12
X
X
1
7
4
10
3
9
NOTE:
SR = Single Rank, DR = Dual Rank, QR = Quad Rank.
Population rules must be followed for both processors.
Memory modules may be populated one at a time per
processor, but populating two at a time per processor
provides better performance.
Memory modules should be populated four at a time per
processor for best performance.
Quad Rank memory module can only be installed in
memory sockets 2, 5, 8, and 11.
CAUTION: DIMMs can be damaged by improper handling.
Always use an anti-static wrist strap and grounding mat, and
discharge static electricity before touching DIMMs.
To install a memory module:
1.
Align the notch on the bottom edge of the module with the keyed
surface of the DIMM slot and then press the module fully into the
slot.
2.
Firmly press the holding clips inward to secure the memory
module in place.
Figure 7 Installing the memory module
DIMM slots are structured to ensure proper installation. If you insert a
5
11
DIMM but it does not fit easily into the slot, you may have inserted it
incorrectly. Reverse the orientation of the DIMM and insert it again.
X
X
6
12
5
Advertisement
Table of Contents
