Table of Contents
Advertisement
FUNCTIONS & CONTROLS CONT.
17) FORWARD SKIP BUTTON - Use this button to
skip to the next track on the CD.
18) FLIP FLOP -
Use a std. mini plug (stereo) to plug in
Side 1 to Side 2. Set both sides of the CD player to
single mode on the control. When Disc 1 ends the
CD player will automatically change to Disc 2 and
when Disc 2 ends it will return to Disc 1, etc.
19) PLAYER 2 REMOTE CONNECTOR - Connect
to player 2 connector on transport assembly.
20) PLAYER 1 REMOTE CONNECTOR - Connect
to player 1 connector on transport assembly.
21) PLAYER 2 MINI CONNECTOR FOR Q START -
Connect to Q Start mixer B connector on enabled
American DJ mixers.
22) PLAYER 1 MINI CONNECTOR FOR Q START -
Connect to Q Start mixer A connector on enabled
American DJ mixers.
C. LCD (figure 5)
1) PLAY INDICATOR (
lights during playback.
2) PAUSE INDICATOR (
indicators light during pause or cue mode.
3) CUE INDICATOR - The CUE indicator lights
during CUE mode or PAUSE mode, flashes when
CUE point is changed.
PREPARATIONS
1. Check that the carton contains the following items:
1)
Main unit
2)
Control unit
3)
Operating instructions ( this booklet)
2. Installing the Units
Mount the units onto your console or rack with 19" EIA rack rails.
CAUTION:
• The player will work normally when the main
unit is mounted with the front panel within
15 degrees of the vertical plane. If the unit is
tilted excessively, discs may not be loaded or
unloaded properly. (Figure 6)
• The control panel's LCDs are designed to be
clearly visible within the angles shown in
Figure 7. Mount the control unit so that the
visual angle is within this range.
) - The PLAY indicator
) - The PAUSE
American DJ
AUDIO • DCD-PRO200MKIII™ INSTRUCTIONS MANUAL • PAGE 9
®
4) ELAPSED INDICATOR - It indicates that the time
shown on the display is the elapsed time.
5) TOTAL INDICATOR - It indicates that the time
shown on the display is the elapsed time.
6) BAR INDICATOR - These ten indicators provide
a visual display of the approximate position of the
pickup within the current track.
7) REMAIN INDICATOR - It indicates that the time
shown on the display is the remaining time of the
playing track.
8) SINGLE INDICATOR - When the indicator light,
playback will stop at the beginning of the track.
9) PROGRAM INDICATOR - The PROGRAM
indicator lights when program mode is set.
10) PITCH INDICATOR - When the indicator lights,
the pitch adjustment is enabled.
11) LOOP INDICATOR - When in loop mode this
indicator will glow.
12) TRACK INDICATOR - Indicates the current track
that is playing, cued, or in pause mode.
13) MINUTES INDICATOR - Display current minutes.
14) SECONDS INDCTOR - Displays current seconds.
15) FRAME INDICATOR - Displays current frames.
16) PITCH PERCENTAGE - This displays the amount
of pitch being applied to the track. This is adjusted
by the PITCH SLIDER.
4)
Two sets of RCA cables.
5)
Two Control cords (6 feet / 1.8 meters)
6)
Two Mini Connectors for "Q" Start.
Fig. 6
Fig. 7
Advertisement
Table of Contents
