Code Search - GE 24993 Instruction Manual

Code Search
If your device does not respond after you have
tried all the codes for your brand, or if your brand is
not listed, try searching for your code by following
these steps.
1. Manually turn on the device (
be controlled.
2. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
3. Press and quickly release the desired
mode button (TV, DVR, etc.). The red
indicator blinks off once.
4. Press the CHAN+ button repeatedly
(up to 300 times) until the device to be
controlled changes channel.
The red indicator blinks off
with each button press. If
you accidentally overshoot
the code required, press the
CHAN- button to backtrack through the library
until the device changes channel. Pressing
CHAN+ changes direction to forward again.
. Press and release ENTER to install the code.
Most users will store DVR codes under the DVR
button, Cable codes under CABLE, etc. If
(for example) you want to store a DVR code
under CABLE, first follow the procedure
for Direct Code Entry (page 7) and press
CABLE in step 2 of Direct Code Entry, then
enter ANY DVR code in step 3 of Direct Code En-
try. Then follow the steps above for Code Search.
Note: If the device does not have a CHAN+ button,
use PLAY (DVR only) or POWER instead. Code Search
starts from the currently stored three digit number under
that mode. Sometimes the first code that "works" with
your device may only allow limited functionality (e.g.,
the MENU button might not work). There may be a code
that performs more functions. Continue the code search
process until the best code is found.
,
TV
8
, etc.) to
DVR