Startup Menu - Lenovo ThinkPad Edge E120 User Manual

Lock UEFI BIOS Settings enable or disable the function that protects items in the ThinkPad Setup from
being changed by a user who does not have the supervisor password. By default, this is set to Disabled.
If you set the supervisor password and enable this function, no one but you can change any items in the
ThinkPad Setup.
If you select Set Minimum Length, you can specify a minimum length for power-on passwords and hard
disk passwords. By default, this is set to Disabled. If you set the supervisor password and specify a
minimum length for passwords, no one but you can change the length.
If you select and enable Password at restart, a password prompt is displayed when you restart the
computer. If you select Disabled, no password prompt is displayed; the computer goes ahead and loads the
operating system. To prevent unauthorized access, set the user authentication on the operating system.

Startup menu

You may need to change the startup sequence of your computer. For example, if you have different operating
systems on different devices, you can have the system start up from either of them.
Attention: After you change your startup sequence, you must be extremely careful not to specify a wrong
device during a copy, a save, or a format operation. If you specify a wrong device, your data and programs
might be erased or overwritten.
Attention: If you are using the BitLocker
BitLocker drive encryption detects the change of startup sequence and locks the computer from booting.
Changing the startup sequence
Select Startup to display the Boot submenu:
To change the startup sequence, do the following:
1. Select Boot; then press Enter.
You can use the Boot submenu to specify the startup sequence that runs when you turn on the power.
Refer to "Boot submenu" on page 103.
2. Select the device you want to start first.
To set the order that the UEFI BIOS will use when starting an operating system, you can press the – or +
key to move the device up or down.
3. Press F10 to save the changes and restart the system.
To change the startup sequence temporarily so that the system starts up from a different drive, do the
following:
1. Turn off the computer.
2. Turn on the computer; then, while the "To interrupt normal startup, press the blue ThinkVantage button"
message is displayed at the lower-left of the screen, press F12.
3. Select the device you want to start first from the Boot menu.
Note: The Boot menu will be shown when the system cannot boot from any devices or operating
system was not found.
Boot submenu
The following list, showing the order in which devices will be started up, is always displayed. Even devices
that are not attached to or installed on your computer are listed. For each device that is attached to or
installed on the computer, information about it is presented after the colon.
1. USB CD:
®
drive encryption, you should not change the startup sequence.
.
Chapter 8 Advanced configuration
103