D-Link DGS-3024 - Switch Manual page 46

The user-changeable parameters are as follows:
Parameter Description
Select an ID number for the group, between 1 and 4.
Group ID [1-4]
Trunk groups can be toggled between Enabled and Disabled. This is used to turn a port trunking
State
group on or off. This is useful for diagnostics, to quickly isolate a bandwidth intensive network
device or to have an absolute backup aggregation group that is not under automatic control.
The types of port trunking supported by the DGS-3024 are Static and LACP.
Type
Master Port Choose the Master Port for the trunk group using the pull-down menu.
Port Map Choose the members of a trunked group. Up to eight ports per group can be assigned to a group.
Active Port Shows the port that is currently forwarding packets.
After setting the previous parameters, click Apply to allow your changes to be implemented. Successfully created trunk groups
will be show in the Current Trunking Group Entries table.
DGS-3024 Gigabit Ethernet Switch Manual
Figure 7- 9. Port Trunking Configuration window
32