AEG OKO-SANTO 2972-6 i Operating And Installation Instructions page 15

Symptom
The food is too warm.
Interior lighting does not
work.
Heavy build up of frost, pos-
sibly also on the door seal.
The compressor does not
start immediately after chan-
ging the temperature set-
ting.
Water on the floor or on sto-
rage shelves.
If, after carrying out the necessary checks there is still a fault with
your appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested
checks have been made as the engineer will make a charge if the
fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee
service calls.
Possible Cause
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air tight
(possibly after reversing the
door).
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Please look in the "Initial
Start Up" section.
Open the door only as long
as necessary.
Turn the temperature control
knob to a colder setting.
Please look in the "Installa-
tion location" section.
Please look in the "Chan-
ging the Light Bulb" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (not hotter
than approx. 50 ¡C). At the
same time shape the war-
med door seal by hand until
it sits correctly.
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.
15