AEG ÖKO-ARCTIS 1050-4 GS Operating Instructions Manual page 20

The freezer temperature is
not sufficient, red light
lights up.
Heavy build up of frost,
possibly also on the door
seal.
Unsual noises.
The compressor does not
start immediately after
changing the temperature
setting.
Important: regularly check on the red temperature pilot light to
ensure that the storage temperature is being maintained.
20
Symptom Possible Cause
Temperature is not
properly adjusted.
Door was open for an
extended period.
A large quantity of warm
food placed in the appli-
ance within the last 24
hours.
The appliance is near a
heat source.
Door seal is not air tight
(possibly after reversing
the door).
Appliance is not level.
The appliance is touching
the wall or other objects.
A components, e.g. a pipe,
on the rear of the
appliance is touching
another part of the appli-
ance or the wall.
This is normal, no error has
occurred.
Remedy
Please look in the "Initial
Start Up" section.
Open the door only as long
as necessary. Press the fast
freeze switch.
Press the fast freeze
switch.
Please look in the
"Installation Location"
section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a
cool setting). At the same
time shape the warmed
door seal by hand such
that it sits correctly.
Readjust the feet.
Move the appliance
slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after
a period of time.