LG LT1010CR Owner's Manual page 16

instalia#on
PROCEDURE C
_ R_iro_ the louvers at the back of the wa_l
sleeve to 60 ° angle as, shown in the FIG 16
The u_ of pliers is, r_ommen_d,
7 _
Rea_Louvers
(Top View)
FIG. 16
lf _e wall sleeve already has a rear gdHe sMp
to step 4. if the walil sleeve d_s not have a rear
9rilile or ]ouvered pane], install the plastic gdlle
fm,m the kit. Cut the plastic gdlle to 26-1/2" wide
and 15o!/2 " high. Place the plastic grille ilo the
inside of the-wail sleeve at the rear flange.
Place the plastic grille
F_G. 17
_ asten the, 4 washer sc[_s to s_ure the grille
to the wall sliec</e, if yes need plastic nu_ to
mount plastic 9riIIle to the inside of the walil
sleeve, there are plastic nuts in the installation
kit. The nuts are insta]l_ from the inside of the
sleeve and are pressed into the square holes of
the rear flanges,
Fasten the screws; FIG. 18,
Remove the ba,_ing from the Horizontal
_nsulatioin strip 23h:32 x 138 x 13,_ and attach
that to the inside right of the sleeve as shown
_low. Remove the ba_.ing from the A_ound
Ins,ulatioin strip 59_h,_2x: 1% x 1% and attach
that t,o the inside front of the slee.te ,as shce_n
_low.
Indoor Out.or
q
8 _
HG. t9
[1the _pth of you_ existing sleeve is less than
or equal to 18", sk_ to step 7. _ePwise, cu_
the baf|l_ and the support b_oc_ according to
Length 'W' in the table _]ow,
Oepth_'D '' of the ,existing Length "A°
18 <D _<18_% s/4
18o%< O_19_/_ 1 3/4
_ emo_ the ba_ing kom the supF:_rt b!lks
and a'_a,ch them to the inside of the wall sleeve
as shown FIG 2'1 Sli@_ the baffle into, sk_ts of
the snppo,# blocks
WS|_
Sleeve
16 Room Air CoinditJonier