Table of Contents
Advertisement
What to do, if...
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Force Centre, please carry out the checks listed
below.
Important: If you call out an engineer to a fault listed below or to repair a fault
caused by incorrect use or installation a charge will be made even if
the appliance is in guarantee.
Symptom
...the programme does not
start
...the machine does not fill
with water
...the machine will not
drain
...the machine is noisy
...the door is difficult to
close
Once you have checked the possible causes listed above, switch on the dishwasher
and start a wash programme, if the fault persists contact the Service Force Centre.
24
Possible cause
The door has not been
properly closed.
The plug is not properly
inserted in the power
socket.
There is a power failure.
The water tap is closed.
The mains water supply has
been cut off.
The inlet hose may be
squashed or bent.
The inlet hose may be
blocked.
The drain hose may be
squashed or bent. The drain
hose extension is not
correct.
The sink may be blocked.
Dishes are rattling against
each other.
The spray arms are
knocking against the
dishes.
The dishwasher is not level,
or not properly built-in.
Remedy
Close the door.
Insert the plug.
Check the fuse.
Open the water tap.
Wait for the supply to be
restored.
Reposition the hose
correctly.
Switch off the water
supply and clean the
filter.
Reposition the drain hose
correctly. Follow the
instructions for
connecting to the waste.
Clear any blockages.
Load correctly crockery,
cutlery, pots and pans.
Refer to "Loading cutlery
and dishes"
Refer to "Installation"
instructions.
Hide quick links:
Advertisement
Table of Contents
