AEG LAVAMAT W 808 User Information page 32

Operating Instructions
Problem
Softener has not been
flushed into machine;
drawer æ for care
agent is filled with wa-
ter.
Washing is heavily
creased.
Washing has not been
spun properly. Residual
water is still visible in
the drum.
Detergent deposits
form in the washing
powder drawer.
The rinsing water is
murky.
Door cannot be
opened.
32
Possible Cause
The softener insert has not
been correctly positioned in-
side the care agent compart-
ment or is blocked.
Probably too much washing
was packed into the drum.
The drain hose is bent.
Maximum pump head (outlet
head 1m from unit's floor
surface) exceeded.
Drain pump is blocked.
Where a siphon is connected:
siphon is blocked.
Water valve is not fully
opened.
Filter in the screw connec-
tion of the inlet hose on the
water valve or on the unit is
blocked.
The cause is probably a
washing powder/liquid with
a high silicate content.
Door is locked for safety rea-
sons.
Remedy
Wash the washing powder
drawer and position the sof-
tener insert firmly.
Follow instructions for the
maximum filling quantity
(see Programme Tables).
Remove the bend.
Contact customer service; a
retrofit kit is available as a
special accessory for pump
heads over 1m.
Switch off the unit and pull
out the mains plug. Clean
the drain pump.
Clean the siphon.
Open the water valve fully.
Close the water valve. Un-
screw the inlet hose from the
water tap and from the unit.
Clean the filter.
No negative influence on the
rinse results; perhaps use liq-
uid washing agent.
Wait for 1 or 2 minutes after
the end of the programme.