Table of Contents
Advertisement
Error Message List
Error Messages
Device Address Conflict
Allocation Error for device
Failing Bits: nnnn
Fixed Disk n
Invalid System Configuration Data
I/O device IRQ conflict
Operating system not found
Error Message List
No beep Error Messages
No beep, power-on indicator turns off and LCD
is blank.
No beep, power-on indicator turns on and LCD
is blank.
No beep, power-on indicator turns on and LCD
is blank. But you can see POST on an
external CRT.
No beep, power-on indicator turns on and a
blinking cursor shown on LCD during POST.
No beep during POST but system runs
correctly.
Chapter 4
FRU/Action in Sequence
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
Main Board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
Main Board
DIMM
BIOS ROM
Main Board
None
BIOS ROM
Main Board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
Main Board
Enter Setup and see if fixed disk and drive A: are properly
identified.
Diskette drive
Hard disk drive
Main Board
FRU/Action in Sequence
Power source (battery pack and power adapter). See "Power
System Check" on page 71.
Ensure every connector is connected tightly and correctly.
Reconnect the DIMM.
LED board.
Main Board.
Power source (battery pack and power adapter). See "Power
System Check" on page 71.
Reconnect the LCD connector
Hard disk drive
LCD inverter ID
LCD cable
LCD Inverter
LCD
Main Board
Reconnect the LCD connectors.
LCD inverter ID
LCD cable
LCD inverter
LCD
Main Board
Ensure every connector is connected tightly and correctly.
Main Board
Speaker
Main Board
75
Advertisement
Table of Contents
