Adjusting Rinse Aid Dosing; Setting The Audible Signal For The End Of The Wash Programme - AEG OKO FAVORIT 80850 i User Instructions

Adjusting Rinse Aid Dosing

The dose should be adjusted according to the finish and drying results
3
obtained. The dose is factory set at 4, and can adjusted from 1 to 6.
Gradually increase the dose if there are drops of water or lime spots on
the dishes after washing. Reduce if it there are sticky whitish streaks on
the dishes.
1. Turn the lid of the container
0
¼ of a turn anticlockwise and
remove.
2. Adjust the dose setting with a tea
spoon.
3. Replace the lid and tighten by turn-
ing clockwise.
4. If rinse aid has run out, wipe up with
a cloth.
Setting the Audible Signal for the End of the Wash
Programme
The dishwasher can be set to exit an audible signal at the end of a wash
cycle.
0 1. The dishwasher must be switched off.
2. Press the signal tone and water softener buttons simultaneously and
keep them pressed.
3. Press the ON/OFF button. The LED indicators for the signal tone and
water softener buttons flash.
4. Press the signal tone button again.
The multi-display indicates the current setting:
b0
b1
5. Pressing the signal tone button changes the setting.
6. Once the multi-display indicates the required setting, press the ON/OFF
button. The setting is then saved.
Signal tone switched off
Signal tone switched on (factory setting)
Operating Instructions
15