Setting The Clock (Remote Control Only) - Sharp SW330 Operation Manual

Setting the clock (Remote control only)

In this example, the clock is set for the 24-hour (0:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the
select "CLOCK", and press the MEMORY button.
4
Press the or
hour display and then press the MEMORY button.
The 24-hour display will appear.
"0:00"
(0:00 - 23:59)
The 12-hour display will appear.
"AM 12:00"
(AM 12:00 - PM 11:59)
"AM 0:00" The 12-hour display will appear.
(AM 0:00 - PM 11:59)
or button to
button to select 24-hour or 12-
5
Press the or
then press the MEMORY button.
Press the or button once to advance the time by
1 hour. Hold it down to advance continuously.
6
Press the or
then press the MEMORY button.
Press the or button once to advance the time by
1 minute. Hold it down to change the time in 5-minute intervals.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the
time.
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time dis-
play when the AC power supply is restored after a power failure or
unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" does not
appear in step 3, step 4 (for selecting the 24-hour or 12-hour dis-
play) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 42 for details.]
2 Perform "Setting the clock" from step 1.
button to adjust the hour and
button to adjust the minutes and
or button to display the
CD-SW330H
ENGLISH
E-12