Table of Contents
Advertisement
SATA Bus Interface and ATA Commands
proprietary ASIC developed by Maxtor.
5.5.2
Supported Commands
The Maxtor QuickView Serial ATA 400/500GB hard disk drive support all the
mandatory commands from the general feature set for devices not supporting the
Packet command feature set. Refer to the ATA/ATAPI-7 standard for a detailed
description of these commands. The IDENTIFY DRIVE command, however, is
elaborated in the section "Identify Drive Command" on page 5-5
Note: 1. As defined in the ATA/ATAPI-7 standard.
Table 5-1 lists the supported commands.
CHECK POWER MODE
DEVICE CONFIGURATION FREEZE LOCK
DEVICE CONFIGURATION IDENTIFY
DEVICE CONFIGURATION RESTORE
DEVICE CONFIGURATION SET
DOWNLOAD MICROCODE
EXECUTE DRIVE DIAGNOSTIC
FLUSH CACHE
FLUSH CACHE EXTENSION
IDENTIFY DEVICE
IDLE
IDLE IMMEDIATE
NOP
READ BUFFER
READ DMA
READ DMA EXTENSION
READ FPDMA QUEUED
5-2
Maxtor QuickView 400/500GB Serial ATA Hard Disk Drive
Table 5-1
Supported Commands
Command
Feature
Command
Register
Code
Value(s)
98h, E5h
B1h
C1h
B1h
C2h
B1h
C0h
B1h
C3h
92h
07h, 01h
90h
E7h
EAh
ECh
97h, E3h
95h, E1h
00h
E4h
C8h, C9h
25h
60h
Advertisement
Table of Contents
