Advertisement
4
To seat the module, firmly push the module forward to engage the module
and backplane connectors. You will feel a slight resistance as the connectors
engage.
CAUTION: If the resistance is too great, the module and backplane connec-
tors may not be aligned. Forcing the module forward could damage the
board or backplane connectors. If necessary, remove and reinsert the
module, ensuring that the connectors are properly aligned. You should not
have to seat the module by tightening the captive screws.
5
Tighten the captive screws to secure the module in the chassis.
Once the module is installed, see Chapter 4: Cabling the System in your
Getting Started guide for information on cabling the module to the network.
Option Module
Module diagnostics run at power up or when replacing a module with the
Diagnostics
power on. During diagnostics, the module's port status Error LEDs are lit
yellow. When diagnostics are successfully completed, the port status Active
LEDs turn green for those ports that are cabled. If any port status Error LEDs
remain yellow, the port is not operational. If the module's Board Error LED
is lit yellow, the module has failed a diagnostic test. To troubleshoot module
failures see Chapter 7: Troubleshooting the System in your Getting Started
guide .
Advertisement
