Troubleshooting And Fault Codes; Something Not Working - AEG Electrolux FAVORIT 35085 VI Instruction Book

Something not working

Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
Important: If you call out an engineer to a fault listed below or to
repair a fault caused by incorrect use or installation a charge will be
made, even if the appliance is in guarantee.
...a fault code appears
The dishwasher will not start or stops during operation and a sequence
of intermittent audible signals are heard.
Open the dishwasher's door
The intervention of an alarm is indicated by:
- the continuous flashing of the indicator light of the running
programme,
- a combination of flashes and pauses of the end of programme
indicator light and by intermittent audible signals (as described in
the chart).
Open the door and carry out the following suggested corrective
actions .
Fault code / Malfunction
- the continuous flashing of the
indicator light of the running
programme
- 1 intermittent audible signal
- 1 flash of the "end of programme"
indicator light
The machine does not fill with water
- the continuous flashing of the
indicator light of the running
programme
- 2 intermittent audible signals
- 2 flashes of the "end of programme"
indicator light
The dishwasher will not drain
- the continuous flashing of the
indicator light of the running
programme
- 3 intermittent audible signals
- 3 flashes of the "end of programme"
indicator light
Possible cause
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in the
threaded hose fitting at the
water inlet valve is blocked.
The water inlet hose has not
been correctly laid or it is bent
or squashed.
The siphon is blocked.
The water drain hose has not
been correctly laid or it is bent
or squashed.
Protection against flooding is
active.
Operating instructions
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
Check the water inlet
hose connection.
Clean out the siphon.
Check the water drain
hose connection.
Close the water tap
nd contact your local
Service Force Centre.
33