If The Hard Disk Drive Does Not Work; If The Cd-Rom Drive Has A Problem - HP Kayak XW U3-W3 Troubleshooting Manual

If the Hard Disk Activity
Light Does Not Work
WARNING
HP Kayak XW U3 & W3 PC Workstation Troubleshooting Your HP PC Workstation
If Your PC Workstation Has a Hardware Problem

If the Hard Disk Drive Does not Work

Check that the disk power and data cables are correctly connected.
•
For an IDE drive, check the IDE Device's configuration settings in
•
the Setup program (Advanced > IDE Devices).
For an IDE drive, check the Hardware Protection settings in the
•
Setup program (Security > Hardware Protection).
For an IDE drive, check the Boot Device Security settings in the
•
Setup program (Security > Boot Devices Security).
For a SCSI drive, check the SCSI Interface settings in the Setup
•
program at Advanced > Internal Wide 16-bit SCSI or External\
Internal 16\8-bit SCSI and in the SCSISelect Utility (Adaptec)or the
Configure SCSI Utility (Symbios).
If the hard disk activity light does not flicker when the PC Workstation
is accessing the hard disk drive:
Check that the control panel connector is firmly attached to the
•
system board.
Check that the disk power and data cables are correctly connected.
•

If the CD-ROM Drive Has a Problem

Be sure to disconnect the power cord and any telecommunication
cables from your computer before you remove the cover to check the
cable connections or jumper settings.
To avoid electric shock and harm to your eyes by laser light, do not
open the CD-ROM drive enclosure. The drive should be serviced by
qualified service personnel only. Refer to the label on the drive for
power requirements and wavelength. Do not attempt to make any
adjustment to the unit. This PC Workstation is a class 1 laser product.
The CD-ROM Drive Does not Work
Check that the cables have been properly connected.
•
Check that the CD-ROM is inserted in the drive.
•
16 English