Viking FDB451 Installation page 2

IMPORTANT–
Please Read and Follow!
• Before beginning, please read these instructions completely and carefully.
• Use caution during assembly to minimize scratches.
• Do not remove permanently affixed labels, warnings or plates from the product. This may
void the warranty.
• Please refer to the product Installation Instructions for more information on
installing the door panel.
• The installer should leave instructions with the customer who should retain for local
inspector's use and future reference.
Installation with Wooden Full Overlay
Custom Door Front
Parts Included
Part Quantity
D3 Handles (1)
End Caps (2)
#10 x 3/4" Hex Head Screws (4)
Installation Instructions (1)
Required Tools
Electric Drill
3/16" (0.5 cm) Drill Bit
7/16" (1.1 cm) Spade or Forstner Bit (Counterbore)
Tape Measure
Hex Head Screw Driver
Masking Tape and Pencil
To Install:
1. Locate the wooden custom panel.
2. Using the illustrations on the next page, layout the handle location on the panels. It is
recommended that masking tape be placed where the four holes will be drilled to help mark
the hole placement and to prevent any damage to the door when drilling the holes.
3. The D3 handle will be mounted using (4) of the #10 x 3/4" Hex head screws provided. Using
the 3/16"(0.5 cm) drill bit, drill completely through the door in the hole locations. Using the
7/16" (1.1 cm) bit, counter-bore four holes 1/2" (1.2 cm) deep max. on the BACKSIDE of the
custom door panel.
4. Attach the D3 handle to the panel using (4) #10 x 3/4" screws provided.
2
Handle Installation
FDB - DISHWASHER
CUSTOM FRONT DIMENSIONS
4
Section A-A