Access The Security Gateway Management Interface (Sgmi) - Symantec 360R - Security Gateway SGS Installation Manual

Access the Security Gateway Management Interface
(SGMI)
Gateway Host Name
Enable
2 Click Next.
3 In the LiveUpdate Settings panel, do the following:
Run LiveUpdate
Enable Scheduler
LiveUpdate Server
Frequency
Preferred Time (UTC)
4 Click Next.
5 In the Confirmation panel, review the settings.
6 Do one of the following:
To make changes, click Back.
■
To save the settings and restart the appliance, click Apply Settings.
■
It takes a few minutes for the appliance to apply the settings and
restart.
Once you have completed the Setup Wizard, you can configure the other
features of the appliance using the SGMI.
You should configure your browser to check for newer versions of stored pages
every visit to the page before accessing the SGMI.

Access the Security Gateway Management Interface (SGMI)

Type the name of the gateway host.
You can leave the default value, or change it if
required by your ISP or leave it blank.
If you do not want to permit PING requests,
under Block ICMP Requests, click this option
button.
To run LiveUpdate after the Setup Wizard is complete,
check this check box.
To run Scheduler, check this check box.
Type the server address.
Select the frequency with which LiveUpdate checks for
updates.
Type the time of day which you want LiveUpdate to check
for updates.
The time is based on a 24-hour clock. The format is
HH:MM, where HH is hour and MM and minutes. For
example, to run the Live Update at 5:30 p. m., type 17:30.
Running the Setup Wizard 29