Initializing The Control Box Panel - Brother S-7200B Service Manual

4. INITIALIZING THE CONTROL BOX PANEL

This returns the control box panel settings to the factory default settings.
NOTE:
The control box panel will not operate when the machine head operation panel is connected.
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
1
2
3
4
(Display turns off)
(5 seconds or more)
5
DANGER
Set DIP switch -3 to OFF.
(This will cancel the lock so that the functions can be set.)
Control box
While pressing the end backtack key (1), press the power
switch (2) to turn on the power.
1.
Press the start backtack key (3) so that "r" is displayed in
the top row of the stitch number display.
2.
Press the end backtack key (1) to set the value in the
bottom row of the stitch number display to "1".
1. Then, press and hold the end backtack key (1) for 5
seconds or more. (The display will turn off.)
2. After this, "Ar" will flash and the initialization will be
complete.
Set DIP switch -3 to ON.
(The settings will be locked.)
S-7200B
4. INITIALIZING THE CONTROL BOX PANEL
3143M
0706B
0707B
3150M
22