Aqua Sensor; Switching On The Appliance; Remaining Running Time Display; Timer Programming - Bosch SMI50C05GB Operating Instructions Manual

A qua sensor *
Aq u a s e n s o r
* depending on model
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The Aqua sensor is used according to
the programme. If the Aqua sensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater, the
water is drained and is replaced with
fresh water. In the automatic
programmes the temperature and
running time can also be adjusted to the
degree of soiling.

Switching on the appliance

1. Turn on the tap fully.
2. Switch on ON/OFF switch (.
3. Rotate programme selector 8 to
the required programme.
The expected programme duration
flashes on the digital display H.
4. Press START button @.
The programme starts running.
Note
- for environmentally friendly operation
of the dishwasher:
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
"Standard programme" which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
Operating the appliance
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display H.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).

Timer programming *

Ti m e r pr o g r a m mi n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button P until the digital
display H jumps to
4. Press button P until the displayed
time corresponds with your
requirements.
5. Press START button @, timer
programming is activated.
6. To delete the preselected starting
time, press the button P until
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when the
value : is indicated on the numerical
display H.
en
: .
is
19