Program (Program Control) - Electrolux Air-O-Speed AOW101E Installation And Operation Instruction Manual

To repeat the same cycle with several PHASES just press the
START/STOP button again.
- SKIP PHASE -
During cooking it is possible to skip one or more phases and go
to the NEXT as indicated below:
- Press the button P2 ( ) to select the PHASES field
- Select the next phase.
- Press the button P1
to skip the phase IN PROGRESS.
- Press the button P2 (
- CANCEL PHASE -
To cancel an already set PHASE, in progress the next phases
must first be eliminated, therefore select the last phase and press
the button P3 ( ) and confirm with P2 (
this operation until reaching the phase to be eliminated.
- DELAY START - (delayed cycle start)
After setting the TIME (refer to par 4.6.4) carry out the following:
1) Turn knob K to select the DELAY START symbol
D
in the phases field.
5) Press the button P2 (
6) With knob K set the required START time and press the START/
STOP button.
Now the cycle will start at the set DELAY START time and the
letter D goes to the left at the beginning of the PHASE field, indi-
cating this function is active.

4.6 PROGRAM (PROGRAM CONTROL)

Foreword: the PROGRAM control is used for storing the cook-
ing cycles after setting them manually; for that purpose, first see
par. 4.3 AUTOMATIC or 4.4 MANUAL, it also allows already ar-
ranged programs to be used (e.g. CLEAN).
Note:
If the oven is switched off after manually setting a cooking cycle,
the data of the setting will be lost, because the electronic board
does not memorize the cooking cycle in manual operation mode.
See STORING RECIPES section 4.6.1.
4.6.1 STORING RECIPES OR PROGRAMS
The RECIPES or programs (or cooking cycles) can be
stored in the oven with a number (in sequence) and an
identification description for the corresponding search.
E.g. 01
COOKING CHICKEN
02
COOKING POTATOES
) to confirm.
) to cancel it, repeat
) to select the TIME field
(RECIPE no.)
(RECIPE description)
After entering a RECIPE with the AUTOMATIC or MANUAL
control (with one or more cooking phases) proceed as follows:
1) press the button P3 (
screen
2) Select the number to be assigned to the recipe (or program)
with knob K.
3) First, press the button P3 (
recipe (without name)
and then the button P2 ( ) to confirm or P3 (
name is to be given to the recipe (with name) skip this point and
go to the next.
4) Press the button P1 (
5) Turn knob K to select the first letter (or digit) of the required
name from those available in the boxes, press P2 (OK) for this to
appear in the list field. Repeat the operation for the next letters
. (or digits) until the complete name has been written.
To change a letter press the button P3 (
required letter is selected and repeat point 5); to cancel the let-
ter insert a space
6) Press the button P1 (
7) Press the button P3 (
and then P2 (
29
) to enter the program memory
) to store the number with the
P1 P3
P2 P3
) to write the recipe name
) or P4 (
).
P1 P2 P3 P4
) to store the name of the program.
) to save the program
P3
) to confirm
P2
EN
) to cancel, or if a
) until the