Setting.date,.Time.preset - NEC NP901W - WXGA LCD Projector Install Manual

2. Setting DATE, TIME PRESET
Before installing a digital certificate on the projector, you are required to set [DATE,
TIME PRESET] for checking the expiration date of the digital certificate.
Set the current date and time (i.e., local time), and the time zone.
Important:
• If setting of [DATE, TIME PRESET] is not correct, a message "authentication error" will be
displayed because of failure of checking the expiration date of the digital certificate when
you install a digital certificate.
• The projector has a built-in clock. The clock will keep working for about  weeks after the
main power is turned off. If the main power is off for  weeks or more, the built-in clock
will cease. If the built-in clock ceases, set the date and time, and the time zone again.
The built-in clock will not cease while in the standby mode.
❶ Display the [DATE, TIME PRESET] set-
ting screen.
• From the on-screen menu, select [SETUP]
→ [BASIC] tab → [TOOLS] → [DATE, TIME
PRESET].
❷ Set the DATE, TIME and TIME ZONE.
❸ After setting, select [OK] and press the
ENTER button.
The DATE, TIME PRESET time has been set.
8
(→ page 1)