Documentation Changes - Intel D845GBV Specification Update

Specification Update for Intel

DOCUMENTATION CHANGES

The Documentation Changes listed in this section apply to the Technical Product Specification for Intel
Desktop Boards using the Intel
incorporated into a future version of that specification.
1. Change to Description of Section 3.8.2, Network Boot
The following note will be added to Section 3.8.2, Network Boot:
#
INTEGRATOR'S NOTE
The F12 key may be disabled during POST by assigning a Supervisor Password
and setting the User Access Level to a value other than Full.
For information about
Supervisor Password and User Access Level
2. Change to Description of Section 3.8.4, Changing the Default Boot
Device During POST
The following note will be added to Section 3.8.4, Changing the Default Boot Device During POST:
#
INTEGRATOR'S NOTE
The F10 key may be disabled during POST by assigning a Supervisor Password
and setting the User Access Level to a value other than Full.
For information about
Supervisor Password and User Access Level
3. Removed Note That Specifies USB 2.0 Support Limited to
Windows* 2000 and Windows XP From Section 1.7.2, USB
The following note will be removed in its entirety from Section 1.7.2, USB:
✏
NOTE
USB 2.0 support has been tested with Windows 2000 and Windows XP drivers
and is not currently supported by any other operating system.

Desktop Boards Using the Intel

845G Chipset (Order Number A81229). All Documentation Changes will be

845G Chipset

Refer to
Section 4.5, page 75
Refer to
Section 4.5, page 75
11