AEG LAVATHERM 37700 Operating Instructions Manual page 27

Symptom
The drying process takes
unusually long
The door cannot be closed
The door cannot be opened
with the DOOR button
The dryer terminates the
drying process automatically:
END is displayed shortly after
program start; no display of
the extent of drying
The drying process takes
unusually long. 4.5 hours
after the beginning of the
drying process:
- END display flashes
- acoustic signal sounds
- discontinuation of the
drying process
- error code C6 is displayed
If you do not find the required information in this manual to remedy a
disturbance, please call the customer service.
Possible cause
Spent air removal
disturbed
Fluff filter is clogged
Fluff filter has not been
inserted correctly and/or
the filter lid not closed
Electric mains plug not
connected
Program selector set to
OFF
Too dry or too little
laundry filled-in for the
selected program
SPECIAL CARE button
pressed and too much
laundry filled-in
Too much laundry
filled-in
Laundry too damp
Something not working?
Solution
Make sure that there are
no kinks in the spent air
hose and/or clean the
spent air removal ducts
Clean the fluff filter
Replace the fluff filter
and ensure the filter lid is
closed
Connect the mains plug
Set a program. The fill-in
door can be opened at
any time by pressing
firmly against the door
(pressing location
Select time program or
higher drying stage (e.g.
EXTRA DRY instead of
CUPBOARD DRY)
Check the program
selection: SPECIAL CARE
button appropriate only
for laundry amounts up
to 2.5kg
Reduce the amount of
laundry filled-in
Pre-dry the laundry more
thoroughly
)
27