Restarting The Hp Netserver - HP D7171A - NetServer - LPr Installation Manual

G. Restarting the HP NetServer
1. Connect the power cords and all other external cables.
2. Turn on the HP NetServer, and verify that it starts properly.
If the HP NetServer is operating in HP NetRAID mode, the
HP NetRAID Adapter BIOS version is displayed, firmware
initializes, and then DRAM = displays the capacity of the
HP NetRAID DIMM.
If you receive error message 0076-98: Could not configure
®
the i960
DIMM is not seated properly in its socket. To correct the
problem, repeat the installation procedure.
NOTE
I/O processor's subsystem IDs, the HP NetRAID
If you need to change to HP NetRAID mode, refer to
Step D in Chapter 5 of the Integrated HP NetRAID
Controller Configuration Guide.
13