Chapter 3
CAUTION
Take care to not damage the ribbon cable that connects the
control panel to the NetServer.
5. Reinstall the control panel in the leftmost slots, and install and tighten the
screws.
To avoid damaging the ribbon cable, verify that the ribbon cable goes
completely back inside the NetServer before mounting the control panel.
NOTE
There are two possible locations for the control panel. Only the
leftmost position is correct for Compaq rack installations.
20
Figure 3-11. Relocate the Control Panel
Installation
Mounting Slots for Compaq racks (on left)
Mounting Slots for HP racks (on right)
Control Panel