Interface Description; Ethernet Interface - Electro-Voice System Controller NetMax N8000 Owner's Manual

3.3 Interface description

Ethernet Interface

By connecting the N8000 system controller via the Ethernet interface, the
communication between the N8000 and one or several PC is possible. This allows
the configuration of N8000 via IRIS-Net software. Furthermore, the whole
connected system (consisting of N8000s and EV Precision Series Remote Control
Amplifiers) can be operated and monitored. By using appropriate network
hardware it is even possible to operate the N8000 via a wireless network (WLAN). The Ethernet
interface on the rear of N8000 is a RJ-45 connector (8P8C). Both 10Base-T and 100Base-TX
Ethernet standards are supported. The connections of the Ethernet interfaces can be seen in the
following figure and table.
Pin Name
1
2
3
6
The pin assignment of the Ethernet connector is shown in the following figure. The connector is
viewed from the contact side.
Pin Assignment of Ethernet jack
Description
Tx+ Transmit+
Tx- Transmit-
Rx+ Receive+
Rx- Receive-
Pin Assignment of Ethernet plug
Colour
Pair
T568A
Green striped
2
Green
Orange striped
3
Orange
Preparations
T568B
Orange striped
Orange
Green striped
Green
NetMax N8000 System Controller
Owner's manual
17