Image Command; Cf_Bright Command; Cf_Cont Command; Cf_Color Command - Sanyo PLC-XW250 - 2600 Lumens Manual

PLC-XW200/250 Expand Serial Command Functional Specifications

8.4 Image Command

8.4.1

CF_BRIGHT Command

Command "CF_BRIGHT_%1"[CR]
"000~063" --------------- Directly select Brightness setting value
%1 "UP" ----------------------- Current Brightness setting value + 1
"DN" ----------------------- Current Brightness setting value – 1
Set Brightness value of user control
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF. (The value is held
in Suspend mode.) This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.4.2

CF_CONT Command

Command "CF_CONT_ÿ 1"[CR]
"000~063" --------------- Directly select Contrast setting value
%1 "UP" ----------------------- Current Contrast setting value + 1
"DN" ----------------------- Current Contrast setting value – 1
Set Contrast value of user control
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF. (The value is held
in Suspend mode.) This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.4.3

CF_COLOR Command

Command "CF_COLOR_%1"[CR]
"000~063" ---------------- Directly select Color setting value
%1 "UP" ------------------------ Current Color setting value + 1
"DN" ------------------------ Current Color setting value - 1
Set Color value of user control
Projector does not save the value set with this command so that it returns its
Details original when projector turning into Stanby mode or ALL is OFF. (The value is held
in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.4.4

CF_TINT Command

Command "CF_TINT_%1"[CR]
"000~063" --------------- Directly select Tint setting value
%1 "UP" ----------------------- Current Tint setting value + 1
"DN" ----------------------- Current Tint setting value – 1
Set Tint value of user control
Projector does not save the value set with this command so that it returns its
Details original when projector turning into Stanby mode or ALL is OFF. (The value is held
in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
15 / 64