Message (Part Code Group 1Nnn); Part Code 1005 - HP StorageWorks P9000 Manual

3 Message (part code group 1nnn)

This chapter includes the error messages with the part code 1005 to 1310.

Part code 1005

Table 25 Error codes (part code 1005)
Part Error
Code Number
1005 1002
1005 1003
1005 1004
1005 1005
1005 1007
1005 1009
1005 1010
1005 1018
1005 1020
Error Message
The specified volume cannot be set as a
command device or a component of a
LUSE volume, because it is being used
as the volume of Remote Copy, Business
Copy, Auto LUN, or Snapshot.
You are trying to set multiple paths to the
same volume from one group.
Multiple volumes are specified to a single
port, group or LUN combination.
The following volumes cannot be
specified when you change the path
configurations:
Volumes that do not exist
Volumes other than the top LUs in
expanded LUs
Volumes reserved by Auto LUN
System Disk volume
Failed to remove the path. The specified
path is the last path of the volumes used
for Remote Copy, Business Copy, Auto
LUN, or Snapshot.
The emulation type of the volumes is not
for open systems, or the volumes are not
mounted.
An error occurred during SVP
processing.
The specified port does not exist. Or the
specified port type is not Fibre port.
Invalid LUN.
Recommended Action
Select another volume.
The configuration information has been
already changed.
Check the settings, and request the
setting of the configuration information
again.
The configuration information has been
already changed.
Check the settings, and request the
setting of the configuration information
again.
Check the settings, then retry the
operation.
Check the setting.
The configuration information has been
changed already. Check the settings,
and request the setting of the
configuration information again.
If this problem persists, please contact
HP Technical Support.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Severity
Level
W
W
W
W
W
W
W
W
W
Part code 1005 55