Input Mode Read Command; Lamp Time Read Command; Setting Read Command - Sanyo PLC-XTC50AL Specifications

PLC-XTC50AL Basic Serial Command Functional Specifications

7.5 Input Mode Read Command

Command "CR1" [CR]
Detail Get currently selected Input No.
Acceptable
Response
Unacceptable

7.6 Lamp Time Read Command

Command "CR3" [CR]
Detail Get total lamp running hours.
Acceptable
Response
Unacceptable

7.7 Setting Read Command

Command "CR4" [CR]
Detail Get screen setting status such as Ceiling/Rear.
Acceptable
Response
Unacceptable
"%1" [CR]
"1" = Input 1 is selected.
"2" = Input 2 is selected.
%1
"3" = Input 3 is selected.
"4" = Input 4 is selected.(only for Networking-capable models)
"?" [CR]
"%1_%2" [CR]
Each lamp data follows in sequence with one space between
each of them.
%1 = lamp No.1
%2 = lamp No.2
%1 ex; "00410_00410" [CR]
▪▪▪▪ → Lamp No.1 = 410 Hours
Lamp No.2 = 410 Hours
Note;
-each data shall be 5 digits.
"?" [CR]
"%1" [CR]
"11" [CR] = Normal Screen Setting
"10" [CR] = Picture is top/bottom reversed. (Status: Rear & Ceiling
ON)
%1
"01" [CR] = Picture is left/right reversed. (Status: Rear ON)
"00" [CR] = Picture is top/bottom and left/right reversed. (Status:
Ceiling ON
"?" [CR]
25/26
)